Reverting UniFi to factory firmware

To revert your UniFi to factory firmware, just follow these steps. For more detailed instructions, you can follow steps from flashing with our firmware but using the factory firmware instead.

1. Put your Access Point into recovery mode

2. Set your IP to 192.168.1.30

3. Open your Console

4. Enter the following commands

tftp 192.168.1.20
bin 
trace 
put UNIFI-FIRMWARE-NAME.bin

5. Wait for file transfer

Lines of code should appear rapidly in your terminal.

The lights on the box will now flash as the firmware installs and the box updates itself. When the lights stop flashing and turn solid, the install is complete.

Further instructions can be found on the Ubiquiti forums here.