Installing Cucumber on D-Link DIR505

This guide covers installing Cucumber on the D-LINK DIR505

You will need the following:


1

Store a copy of the Cucumber firmware on your computer

2

Connect an Ethernet cable between the LAN port on the router and the network port on your computer

3

Configure the PC with a static IP address other than 192.168.0.1 (e.g. 192.168.0.5)

4

Power down the router

5

Press and hold the reset button on the router for 3 to 5 seconds and re-plug the power without releasing the reset button

6

Continue to hold the reset button until the red power light keeps blinking on and off

7

Open a web browser and enter the following address: http://192.168.0.1/

8

Wait for the 'D-Link Router Recovery Mode' page to load

9

Click Choose File, select the Cucumber firmware you downloaded and then press Upload

10

After the new Cucumber firmware has successfully loaded, a Success page will display

11

If the Success page fails to display, then repeat steps 4 through 9